Miter Saw / November 10, 2018 / OdeletteGervais.
I. Compound Miter Saws On a compound miter saw the blade moves in three general directions. First the blade moves up and down in a chopping motion. Second the blade moves about 45-degrees to the left and right for miter cuts and lastly the blade will lean either to the left or to the left and right to perform bevel and double bevel cuts. Although compound miter saws are typically more portable and less expensive than sliding compound miter saws they also have less capacity for wider boards. Most often a compound miter saw will be unable to through-cut a wide board with a single pass. II. Sliding Compound Miter Saws A sliding compound miter saw does all of the things a compound miter saw does while also adding a few more things to the pot.
If you can use the entire 4-foot width of the Melamine or particle board by all means do so especially if your miter saw is of the "sliding compound miter" type. As for overall table height I would suggest that you build the miter saw table so that the top of the table comes to your belt line when standing. This will give you a comfortable working height and still allow you to bend over the table. There should be a gap cut through saw table top in the area where the saw is to be mounted. This gap must be exactly as wide as the top of your miter saw and must be open to the front of the table. The gap should close behind the top of the miter saw.
The most portable power miter saw has a blade of eight (8) to twelve (12) inches. The power miter saws cut your woodwork in a certain motion and is against a fence where it produces an angle that is so precise. Since the birth of the first chop saw miter saws have steadily become more advanced more popular and incredibly more useful. In fact where precision crosscuts and accurate miters are concerned there is scarcely a better tool than a miter saw. Allowing users to work faster and with far greater accuracy to perform compound miter cuts bevel cuts and to work with larger pieces of material the multipurpose miter saw is a tool that little else can contest.
I quickly realized that the tool of choice would be a compound miter saw especially when tackling the crown moldings. I had suffered through a bookcase project a year earlier using a manual miter box and back saw to produce the crown molding trim on several built-in bookcases. There was no way I wanted to repeat that experience! My wife eager to see the remodeling project underway readily agreed to a new saw purchase. A Saw By Any Other Name Miter (or mitre) saws are designed to make angled cuts in wood stock by pulling a circular blade down in a plunging motion. This action gives the saws their nicknames of "drop saws" or "chop saws." A further refinement the compound miter saw can cut both an angle and a bevel simultaneously removing the need for a "work-and-turn" motion when making an angled cut that will smoothly join to another piece of trim or molding. The double action cut is possible because the motor is attached to a pivoting post which allows the blade to swing both side to side and at an angle to the workpiece.