Miter Saw / November 15, 2018 / OdeletteGervais.
Make certain to turn the nut in the direction indicated on the saw as most are reverse threaded. While this area of your saw is open you should blow any lingering dust or debris. Dust will accumulate around the center of the blade which can effect the blades alignment and consequently the accuracy of its spin. You should also check the washer and mounting plate for security and for any dust or residual buildup. Simply use any standard scouring pad to remove rust or residue. General Tips: Miter Table Top: Its not only important to keep dust away from your blade its also crucial to keep dust off the miter saw table. Keeping the saw table surface clean keeps you safe and ensures a cleaner more precise cut. Its also good practice to not oil or lube the table top as you dont want any materials sliding or slipping during a cut. Essentially its important to keep the saw table surface clean but also to keep it slip free for the security of your materials and fingers. Miter Fence: A good fence is crucial for cutting accuracy.
To ensure accuracy and control Hitachi miter saw also has linear ball bearing slide system. Hitachis miter saw is also designed to maintain RPM while cutting because it has an electronic speed control system. Its fully adjustable patented chip deflector would also ensure that no tear-outs would happen. And that is not the end of it all. Hitachi miter saw is also convenient to use. Most power miter saw users complain that their tools are just too difficult to start. Sometimes starting the motor is such a drag that you would just simply get frustrated and lost the spark to do work. Well that will not happen with a Hitachi miter saw. From start to finish users will feel comfortable with Hitachis miter saw. Starting up would not be a hassle: with its electronic soft start feature users can maintain their positive moods to do quality work throughout the day. Precision convenience and comfort-these are the things that every woodworker and carpenter would like to have with their miter saws. And you will exactly get those benefits with a high-quality Hitachi miter saw. A miter saw is one of the most commonly owned and commonly used power tools in the industry.
If you can use the entire 4-foot width of the Melamine or particle board by all means do so especially if your miter saw is of the "sliding compound miter" type. As for overall table height I would suggest that you build the miter saw table so that the top of the table comes to your belt line when standing. This will give you a comfortable working height and still allow you to bend over the table. There should be a gap cut through saw table top in the area where the saw is to be mounted. This gap must be exactly as wide as the top of your miter saw and must be open to the front of the table. The gap should close behind the top of the miter saw.
The saw must be mounted in this gap so that the top of the miter saw table is flush with the top of the saw table. The miter handle must be free to move its full travel in both directions left to right. Anticipate the need for this gap as you are framing the underside of your miter saw table because you will need to construct a shelf underneath to support the weight of the miter saw. You might want to make this shelf adjustable in micro increments so that you can get the top of the saw platform exactly flush to the top of the saw table. You can do this with lag screws with washers in sliding slots through the shelf sub-structure and into the table framing. Slightly loosen the lags and tap the table up or down with a rubber hammer before tightening the lags fully.