Miter Saw / October 25, 2018 / Albertina Davide.
If you do find that you have to cut a piece that is larger than six inches and all you have is a 10 inch miter saw you do have a couple of options. The first is that you can simply cut as far as you can and then flip the piece over the finish the cut. The downside is that not all angles can be cut this way. The other issue is that lining up the cuts can be a problem although a laser on your saw will make things a lot easier. Another option that you may want to consider if you have a piece that is a little bit too big for your 10 inch miter saw is to use a piece of wood to raise the cutting deck. This will allow you to get closer to the middle of the blade which will give you more distance. Not all saws have the motor mounted high enough off the deck to make this possible so you will have to check if this is an option with your saw. If you do use this method make sure that you attach the wood firmly to the deck so that it does not slide around while you are cutting. The above methods for making cuts larger than six inches with a 10 inch miter saw are stop gaps that you can use if it is something that only happens occasionally.
And lastly is the table extension where it balances and stops your wood. Miter saw blades also have its different sizes and classifications which are classified into three. 1. The first one is the steel blades which are normally used for plywood and is the least expensive of the three. 2. Second is the high-speed blades which are used both in soft and hard concrete. 3. Third is the carbide-tipped which is the long-lasting and the most expensive of the three blades. Those are the miter saws common features and the kinds of blades that would give you a hint on what miter saw you need. The manual miter saw are only used oftentimes by woodworkers in making frames and produces simpler cuts than that of the compound miter saws.
Make certain to turn the nut in the direction indicated on the saw as most are reverse threaded. While this area of your saw is open you should blow any lingering dust or debris. Dust will accumulate around the center of the blade which can effect the blades alignment and consequently the accuracy of its spin. You should also check the washer and mounting plate for security and for any dust or residual buildup. Simply use any standard scouring pad to remove rust or residue. General Tips: Miter Table Top: Its not only important to keep dust away from your blade its also crucial to keep dust off the miter saw table. Keeping the saw table surface clean keeps you safe and ensures a cleaner more precise cut. Its also good practice to not oil or lube the table top as you dont want any materials sliding or slipping during a cut. Essentially its important to keep the saw table surface clean but also to keep it slip free for the security of your materials and fingers. Miter Fence: A good fence is crucial for cutting accuracy.
Producing a virtually unparalleled smoothness of cut the tool is unbelievably precise and offers optimal operator control throughout every conceivable working condition. The new axial system completely replaces the miter saws former and comparatively underdeveloped rail system with two multi-joint articulating (or hinged) arms which appear more akin to a space-robot than a power tool. These cast-iron arms also ensure the saw remains properly aligned and calibrated despite time and unfavorable environments. Additionally the saws axial design is not only responsible for its unmatched durability and crazy-smooth precision but it also folds to sit flush with the back of the saw saving up to 12" of workspace compared with a standard sliding compound miter saw.