Miter Saw / October 30, 2018 / Sally Abrahamsson.
Make certain to turn the nut in the direction indicated on the saw as most are reverse threaded. While this area of your saw is open you should blow any lingering dust or debris. Dust will accumulate around the center of the blade which can effect the blades alignment and consequently the accuracy of its spin. You should also check the washer and mounting plate for security and for any dust or residual buildup. Simply use any standard scouring pad to remove rust or residue. General Tips: Miter Table Top: Its not only important to keep dust away from your blade its also crucial to keep dust off the miter saw table. Keeping the saw table surface clean keeps you safe and ensures a cleaner more precise cut. Its also good practice to not oil or lube the table top as you dont want any materials sliding or slipping during a cut. Essentially its important to keep the saw table surface clean but also to keep it slip free for the security of your materials and fingers. Miter Fence: A good fence is crucial for cutting accuracy.
The saw does not feature the "soft-start" feature found on some-saws so it does jump a little on startup. I simply have to wait a second or two until the blade has spun up to its full 4600-rpm speed and then make my cut. This gives me a little extra time to consider the cut Im about to make remembering the old adage of "measure twice and cut once. Another feature I really like on this saw is the electric brake on the blade. These brakes immediately slow the blade when you release the trigger. If a blade does not have an electric brake it can spin for 10 seconds or longer which can represent a real hazard to you or to the stock youre removing from the fence. My venerable old table saw (also a Makita) came with the electric brake feature and has made me a real believer in this safety device. Miter saw blades come in a variety of materials. Less expensive blades are usually made of steel and are fine for quick jobs using soft woods such as pine but they will dull quickly if youre using hard woods like oak.
Before joining the two boards together slotted holes should be cut into the back-up board for the purpose of mounting and adjusting the fence position on the table top with reference to the fence on the miter saw. These slots should be slightly wider than the shaft diameter of the lag screws you intend to use to mount the fence to the table. Cut a few equally spaced slots in the back-up board perpendicular (at right angle) to the fence. A 2 x 4 joist should be located under the table top centered underneath the slots in the back-up board. This will give the lag screws something solid to bite into.
For you to choose the right miter saw you have to know its features. Miter saws vary in brands designs and also its blades. The blade guard which is known as a safety blade. A laser guard which serves as a guide of the portion you are about to cut. The shaft lock which helps you in changing the blades of your miter saw. Then the dust bag basically collects the dust of your woodwork. The electric brake is the most important features of your miter saw. The electric brake is one of its safety features which automatically shut down the blade in case of emergency.