Miter Saw / November 22, 2018 / Sally Abrahamsson.
Use a long straightedge in all directions to make sure that the miter saw and the miter saw table are flush with each other. Mount the saw securely to the shelf using lag screws. Once the miter saw is mounted you can begin to construct the fence or fences. A simple inexpensive fence can be constructed using 1 x 4 or 1 x 6 clear fir boards. These boards should be hand selected for straightness and jointed on one edge. One board will be the actual fence and the other will keep it straight from behind. The fence sits with its jointed edge on the saw table top while the back-up board lies flat on the table behind the fence with its jointed edge joined to the bottom of the fence.
Weighing only 24.2 lbs an extremely low and terribly convenient weight for such a powerful and functional tool is extremely easy to move about your home or shop. It can also be easily transported from one job or project to another. This saw provides a welcome and down-sized alternative to the bigger super heavy-duty miter saws of the industry while still offering big power and compound cutting operations. Its 10" capacity is big enough to tackle most heavy applications and its Makita motor is just as powerful as many of the industrys bigger saws. Ultimately this little sucker has a bit more punch than you might expect but rarely does one complain of having a surplus of power and charm as this tool certainly does.
For starters a sliding compound miter saw is designed with two rail-like tubes that allow the blade to move back and forth in a larger range of motion. This grows crosscutting capacity by a few inches and allows users to through-cut wider boards (usually with one easy pass). Because of these tubes though sliding compound miters saws are typically heavier they are less portable and theyre more expensive. With the exception of some Bosch and Makita saws that utilize a kind of articulating arm in lieu of sliding-tubes sliding compound miters also require more room (especially at the rear of the saw) to work properly.
The longer you can build it the better off it will be for you but any length of saw table is better than no table at all. My miter saw table measures 8 Feet to the left of the saw blade and another 8 feet to the right of the saw blade. This way I can support the full length of a sheet of plywood on either side. The saw table is constructed over 2 x 4 framing and contains multiple storage drawers below the table which I use to store small tools and supplies. If you prefer the space underneath the saw table can be left open for shelf space or lumber storage. I suggest that the top surface be 3/4" Melamine or Formica over 3/4" particle board.