Miter Saw / October 27, 2018 / Evelin Nordin.
The saw must be mounted in this gap so that the top of the miter saw table is flush with the top of the saw table. The miter handle must be free to move its full travel in both directions left to right. Anticipate the need for this gap as you are framing the underside of your miter saw table because you will need to construct a shelf underneath to support the weight of the miter saw. You might want to make this shelf adjustable in micro increments so that you can get the top of the saw platform exactly flush to the top of the saw table. You can do this with lag screws with washers in sliding slots through the shelf sub-structure and into the table framing. Slightly loosen the lags and tap the table up or down with a rubber hammer before tightening the lags fully.
The saws all metal bevel lock lever and range selector are also integrated perfectly into the front of the saw eliminating the need for users to crawl around the thing to make adjustments. The tools soft-grip trigger handle is also ergonomic and ambidextrous for the most comfortable use for every craftsman. The GCM12SD additionally boasts Boschs high-precision Squarelock fence famous for requiring no adjustments its one touch lock/unlock slide and its always stable fence support. Precision machining also ensures the two-piece fence is always aligned to the table top at exactly 90° to produce cuts accurate enough to predict the weather (so to speak). Each side of the miter saw also sports integrated expanding base extensions or material supports that pull-out and lock into position to provide 40 inches left-to-right material support - thats a full 60% more than the leading competitor.
And lastly is the table extension where it balances and stops your wood. Miter saw blades also have its different sizes and classifications which are classified into three. 1. The first one is the steel blades which are normally used for plywood and is the least expensive of the three. 2. Second is the high-speed blades which are used both in soft and hard concrete. 3. Third is the carbide-tipped which is the long-lasting and the most expensive of the three blades. Those are the miter saws common features and the kinds of blades that would give you a hint on what miter saw you need. The manual miter saw are only used oftentimes by woodworkers in making frames and produces simpler cuts than that of the compound miter saws.
If you can use the entire 4-foot width of the Melamine or particle board by all means do so especially if your miter saw is of the "sliding compound miter" type. As for overall table height I would suggest that you build the miter saw table so that the top of the table comes to your belt line when standing. This will give you a comfortable working height and still allow you to bend over the table. There should be a gap cut through saw table top in the area where the saw is to be mounted. This gap must be exactly as wide as the top of your miter saw and must be open to the front of the table. The gap should close behind the top of the miter saw.