Miter Saw / December 3, 2018 / Tina Abrahamsson.
Some saws can also be hooked up to a shop-vacuum for easier disposal and better collection. Upkeep: Brushes: Be certain to check your brushes every-so-often for wear and tear. Its important to keep healthy brushes in your tools for performance purposes but it also helps in diagnosing a problem. If you already know the condition of your brushes you either know the brushes are bad or that the problem lies somewhere else. Power Cords:Check power cords for cracks or fraying. Faulty cords will obviously prevent power from getting to your tools but they also present a safety hazard. Additionally if you must use an extension cord use the shortest length possible reach your project. Cleanliness: Keep the tool blown out and your parts clean and tight.
Weighing only 24.2 lbs an extremely low and terribly convenient weight for such a powerful and functional tool is extremely easy to move about your home or shop. It can also be easily transported from one job or project to another. This saw provides a welcome and down-sized alternative to the bigger super heavy-duty miter saws of the industry while still offering big power and compound cutting operations. Its 10" capacity is big enough to tackle most heavy applications and its Makita motor is just as powerful as many of the industrys bigger saws. Ultimately this little sucker has a bit more punch than you might expect but rarely does one complain of having a surplus of power and charm as this tool certainly does.
Blade changes are generally pretty simple so dont avoid blade switching out of inconvenience. Using an improper blade can cost you much more in the long run than a few short minutes to pop on a new blade: when cutting to achieve a cleaner more precise cut use a blade with more teeth for a quicker more rough cut use a blade with fewer teeth when crosscutting be sure to use a crosscut blade and so forth. Blade Changes: To change your blade you first need to remove the guard and pivot the blade mount cover or access plate away from the blade and remove the center nut.
If you can use the entire 4-foot width of the Melamine or particle board by all means do so especially if your miter saw is of the "sliding compound miter" type. As for overall table height I would suggest that you build the miter saw table so that the top of the table comes to your belt line when standing. This will give you a comfortable working height and still allow you to bend over the table. There should be a gap cut through saw table top in the area where the saw is to be mounted. This gap must be exactly as wide as the top of your miter saw and must be open to the front of the table. The gap should close behind the top of the miter saw.