Miter Saw / November 23, 2018 / Tina Abrahamsson.
Miter saws are one of the most popular most widely used power tools in the tool industry today. Because of their portability convenient capacities and overall accuracy a miter saw can be found in nearly every wood-shop garage or pickup truck. Miter saws are generally designed to produce fast accurate crosscuts into a workpiece typically for framing or molding applications. The workpiece is pressed up against an angled fence to ensure the most precise cutting angles as you work. The fence generally sits at a 900 angle but can be adjusted as needed for a particular cut. While most miter saws have a miter index that allows users to precisely modify their cut angle in one degree increments most also have capacities which allow for quick and accurate cut stops at common cut angles like 150 300 and 450.
The bigger the blade the more expensive it will cost you but most of the time bigger blades have more uses than the smaller ones. In choosing the right miter saw you have to decide on whether you will buy the manual or the compound miter. You also have to compare its prices or on how much money are you willing to spend for a miter saw. You also have to pick which is more suitable and useful for your work. A manual or a standard miter saw would be helpful for you if you only intend to make simple cuts on your woodwork while the compound is for more complex woodworks.
Screw the fence to the table loosely so that it can be adjusted. Use the long straight edge on the miter saws table and on the front of the fence to align the fence perfectly and screw down tightly. Repeat for the other side of the table if there is one. For the left fence place a "right to left" reading stick-on measuring tape along the top of the fence. For the right fence place a "left to right" reading stick-on measuring tape along the top of that fence. Before sticking down the tapes must be aligned perfectly. The left tape is measuring the distance from the left side of the saw blade teeth and the right tape is measuring the distance from the right side of the saw blade teeth. With a simple wooden fence like this you can use wooden stop blocks clamped to the fence with C-clamps for repetitive cuts.
I. Compound Miter Saws On a compound miter saw the blade moves in three general directions. First the blade moves up and down in a chopping motion. Second the blade moves about 45-degrees to the left and right for miter cuts and lastly the blade will lean either to the left or to the left and right to perform bevel and double bevel cuts. Although compound miter saws are typically more portable and less expensive than sliding compound miter saws they also have less capacity for wider boards. Most often a compound miter saw will be unable to through-cut a wide board with a single pass. II. Sliding Compound Miter Saws A sliding compound miter saw does all of the things a compound miter saw does while also adding a few more things to the pot.