Miter Saw / October 30, 2018 / Sally Abrahamsson.
There is however some variation in this so you will have to check your particular saw. If you look at your saw blade you will notice that it is wider in the middle than it is in at the bottom or the top clearly the closer to the middle of the blade you can get when you are making the cut the wider you will be able to go. Some saws allow you to go deeper than others particularly if you are using a compound miter saw. This will allow you to get another inch or so. That being said you should probably not expect to get more than six inches with a 10 inch miter saw. One thing to keep in mind is that the six inches that you get refers to a straight cut this is something that a lot of people dont think about when they are buying a miter saw. They assume that because it can cut six inches they will have no trouble cutting a 2x6 this is not however the case. If you cut a miter on a 2x6 the distance that you have to go is going to be a lot longer than six inches. If you have a 10 inch miter saw you should assume that a 4x4 is the biggest piece that you will be able to cut.
Miter saws can be used in a woodworking shop as a permanently installed tool or on the jobsite as a portable or semi-portable unit. I will discuss the construction of miter saw tables appropriate to both types of installations. The purpose of a miter saw table is two-fold: (1) to elevate the saw to a comfortable working height for the operator and (2) to provide a surface to the left and/or right of the saw for the extension of the fence and to provide support for long materials while being cut. If you have ever tried to cut a 45-degree miter at one end of a 2 x 6 x 12 you know why a miter saw table or roller stand is absolutely required. Very often miter saws are used to make repetitive cuts of the same length.
Slide the guard up slightly. This will reveal the screw that holds the guard to the miter saw. Loosen that screw so that you can slide the blade guard further backward. Slide it back as far as it will go positioning it about 170-degrees behind its usual position. This gives you access to the saws locking pin and blade bolt. Depress the saws locking pin (in the very center of the blade) and spin the saw blade until it locks. If your saw does not have a locking pin wedge your scrap wood (ideally a piece of 2x4) in front of the blade to prevent it from moving. Next using an Allen wrench (or an open-ended wrench) remove the blade bolt. Though many saws have a reverse threaded blade bolt the thread pattern is not universal to all miter saws. Accordingly you should look for an indicator on the tool of which way to loosen the bolt or review your tools manual before going to town on it. Remove the flange and finally remove the blade.
These precise miter cuts are made with the downward motion of a circular saw blade that spins with the power of the tools motor. There are several types of miter saw available the standard miter a compound miter and a sliding or compound sliding miter saw. The standard miter has a blade pivot from right to left to cut miters; this saw is however becoming less popular as compound miters have more applications and are only slightly more expensive. Compound miters have the ability to bevel cut or tip the blade to either the left or right side (00 - 500). Some can bevel in both directions allowing operators to miter and bevel within the same cut (-500 through 500). A sliding miter saw is just like a compound miter but with extension rods that allow the saw blade and motor to move forward and back.