Miter Saw / November 12, 2018 / OdeletteGervais.
Slide the guard up slightly. This will reveal the screw that holds the guard to the miter saw. Loosen that screw so that you can slide the blade guard further backward. Slide it back as far as it will go positioning it about 170-degrees behind its usual position. This gives you access to the saws locking pin and blade bolt. Depress the saws locking pin (in the very center of the blade) and spin the saw blade until it locks. If your saw does not have a locking pin wedge your scrap wood (ideally a piece of 2x4) in front of the blade to prevent it from moving. Next using an Allen wrench (or an open-ended wrench) remove the blade bolt. Though many saws have a reverse threaded blade bolt the thread pattern is not universal to all miter saws. Accordingly you should look for an indicator on the tool of which way to loosen the bolt or review your tools manual before going to town on it. Remove the flange and finally remove the blade.
A saw with a compound feature is called as compound miter saw or CMS. - A slide allows the cutting blade to be moved several inches along the cutting plane which in turn allows the cutting blade to make cuts which are longer than the diameter of the blade. A slide which combines the features of slide and compound miter saw is called as sliding compound miter saw or SCMS. - A laser guide gives the exact indication of where the cut will be made in the work piece in the arrangement. - A blade guard is a cover for the sharp teeth of the cutting blade. Most modern saws have a self retracting blade guard which automatically retract when the blade is lowered onto a work piece and re-cover the blade when it is raised. One question that a lot of people have when they are buying a miter saw is just how wide of a cut can be made with this particular saw. In this article we will look at how big a cut a 10 inch miter saw can make since they are by far the most common size. We will also discuss what you can do if you need to make a bigger cut. A standard 10 inch miter saw can handle cuts of up to six inches in most cases.
With the exception of Bosch miter saws whose bevel controls are conveniently up-front most saws bevel controls are placed at the back of the saw. While this is typical and more-or-less intentional it has proved less ergonomic than up-front access. Extension Wings: To increase cutting capacities some saws are also built with slide-out extension wings to support larger boards. While in theory this is a great feature unless you invest in a more expensive tool these wings are often not all theyre cracked up to be. Conversely on a more high-quality saw theyre a definitely a convenient extra.
The standard miter has a blade pivot from right to left to cut miters; this standard saw is however becoming less popular as compound miters have more applications and are only slightly more expensive. Compound miters have the ability to bevel cut or tip the blade to either the left or right side (0° - 50°). Some can bevel in both directions allowing operators to miter and bevel within the same cut (-50° through 50°). Lastly a sliding miter saw is just like a compound miter but with extension rods that allow the saw blade and motor to move forward and back. This motion increases the blade cut capacity enabling the cut length to be longer than the blade diameter.