Miter Saw / October 27, 2018 / Evelin Nordin.
Makitas LS1016L with a 10" capacity is brilliantly handsome at no sacrifice to quality or functionality. As a dual-bevel sliding compound miter saw is also has some pretty exclusive technologies that quickly solidify this tool as a giant among other miters. The saw weighs only 52.2 lbs and boasts the most compact design in its class. This coupled with an exclusive dual sliding fence system (which allows for upper and lower fence adjustments which in turn equals greater cutting accuracy) and a linear ball bearing construction renders the saw impossibly smooth solid and always accurate. This little giant from Makita is tough and smooth and offers craftsmen a smaller lighter more manageable saw while still delivering authoritative power and all the innovative perks of an industrial saw.
There are three basic types available; the power miter saw compound miter saw or sliding compound miter saw. The power miter saw is a basic model that is good for a person who only intends to make simple cuts of 90 degrees or less such as the cuts necessary for trimming studs to frame a house. A compound miter saw is more versatile than the simpler power model since it adjusts for both miter and bevel cuts. Sliding compound models are more advanced and most versatile model of all miter saws. Because the motor and blade assembly is mounted on a movable arm this saw is perfect for accommodating longer pieces of wood while still performing beautiful cuts on smaller pieces as well. If the project you are doing around the house is quite extensive you might want to consider also purchasing a miter saw stand. The stand is one of the most important elements of a miter saw setup. If the saw does not have a good stable place to sit operating the machine will be frustrating and tedious. A stand will also provide a place for very long pieces of wood to rest while being cut. The purpose you intend to use the saw for will determine what type of stand you should purchase.
The saw must be mounted in this gap so that the top of the miter saw table is flush with the top of the saw table. The miter handle must be free to move its full travel in both directions left to right. Anticipate the need for this gap as you are framing the underside of your miter saw table because you will need to construct a shelf underneath to support the weight of the miter saw. You might want to make this shelf adjustable in micro increments so that you can get the top of the saw platform exactly flush to the top of the saw table. You can do this with lag screws with washers in sliding slots through the shelf sub-structure and into the table framing. Slightly loosen the lags and tap the table up or down with a rubber hammer before tightening the lags fully.
I. Compound Miter Saws On a compound miter saw the blade moves in three general directions. First the blade moves up and down in a chopping motion. Second the blade moves about 45-degrees to the left and right for miter cuts and lastly the blade will lean either to the left or to the left and right to perform bevel and double bevel cuts. Although compound miter saws are typically more portable and less expensive than sliding compound miter saws they also have less capacity for wider boards. Most often a compound miter saw will be unable to through-cut a wide board with a single pass. II. Sliding Compound Miter Saws A sliding compound miter saw does all of the things a compound miter saw does while also adding a few more things to the pot.