Miter Saw / November 30, 2018 / Tina Abrahamsson
With the exception of Bosch miter saws whose bevel controls are conveniently up-front most saws bevel controls are placed at the back of the saw. While this is typical and more-or-less intentional it has proved less ergonomic than up-front access. Extension Wings: To increase cutting capacities some saws are also built with slide-out extension wings to support larger boards. While in theory this is a great feature unless you invest in a more expensive tool these wings are often not all theyre cracked up to be. Conversely on a more high-quality saw theyre a definitely a convenient extra.
A saw with a compound feature is called as compound miter saw or CMS. - A slide allows the cutting blade to be moved several inches along the cutting plane which in turn allows the cutting blade to make cuts which are longer than the diameter of the blade. A slide which combines the features of slide and compound miter saw is called as sliding compound miter saw or SCMS. - A laser guide gives the exact indication of where the cut will be made in the work piece in the arrangement. - A blade guard is a cover for the sharp teeth of the cutting blade. Most modern saws have a self retracting blade guard which automatically retract when the blade is lowered onto a work piece and re-cover the blade when it is raised. One question that a lot of people have when they are buying a miter saw is just how wide of a cut can be made with this particular saw. In this article we will look at how big a cut a 10 inch miter saw can make since they are by far the most common size. We will also discuss what you can do if you need to make a bigger cut. A standard 10 inch miter saw can handle cuts of up to six inches in most cases.
The saw must be mounted in this gap so that the top of the miter saw table is flush with the top of the saw table. The miter handle must be free to move its full travel in both directions left to right. Anticipate the need for this gap as you are framing the underside of your miter saw table because you will need to construct a shelf underneath to support the weight of the miter saw. You might want to make this shelf adjustable in micro increments so that you can get the top of the saw platform exactly flush to the top of the saw table. You can do this with lag screws with washers in sliding slots through the shelf sub-structure and into the table framing. Slightly loosen the lags and tap the table up or down with a rubber hammer before tightening the lags fully.