Miter Saw / November 30, 2018 / Tina Abrahamsson
Blade changes are generally pretty simple so dont avoid blade switching out of inconvenience. Using an improper blade can cost you much more in the long run than a few short minutes to pop on a new blade: when cutting to achieve a cleaner more precise cut use a blade with more teeth for a quicker more rough cut use a blade with fewer teeth when crosscutting be sure to use a crosscut blade and so forth. Blade Changes: To change your blade you first need to remove the guard and pivot the blade mount cover or access plate away from the blade and remove the center nut.
Producing a virtually unparalleled smoothness of cut the tool is unbelievably precise and offers optimal operator control throughout every conceivable working condition. The new axial system completely replaces the miter saws former and comparatively underdeveloped rail system with two multi-joint articulating (or hinged) arms which appear more akin to a space-robot than a power tool. These cast-iron arms also ensure the saw remains properly aligned and calibrated despite time and unfavorable environments. Additionally the saws axial design is not only responsible for its unmatched durability and crazy-smooth precision but it also folds to sit flush with the back of the saw saving up to 12" of workspace compared with a standard sliding compound miter saw.
Most of these miter saws are portable with blade sizes ranging from eight to twelve inches. This saw works by pulling a circular saw blade down onto a work piece in a short controlled motion the work piece being held against a fence. This fence provides an accurate cutting angle between the blade and the longest work piece edge. In a standard position this angle is fixed at 90 degrees. The primary feature that distinguishes this saw from others is its miter index that allows the angle of the blade to be altered relative to the fence. Whereas most miter saws provide a facility to make a one degree incremental change to the miter index many also provide stops that allow the miter index to be properly set to common angles of repose like 15 degrees 30 degrees or 45 degrees. Some salient features of the sliding miter saws are as under: - A compound feature allows the angle of the cutting blade to be altered relative to the cutting plane. This also allows the saw to be used for bevel cutting.