Miter Saw / October 26, 2018 / Daniela Nilsson.
This also allows you to push the tool directly against a wall for use with literally zero clearance behind it and because the saw is insanely compact (weighing only 65 lbs) its simple to use in cramped low-space work-spaces and convenient to store and transport. In place of the sliding rail interface of former saws 12 sealed ball bearings make up the GCM12SDs new enclosed system one that maintains its integrity for essentially all-time providing the smoothest blade movement and vastly better control. Because this system is also enclosed its bearings and rollers wont accumulate jobsite debris thus ensuring it remains with a glide like nobodys business for its entire life-cycle. The thing also features a glide damper allowing you to adjust the saws resistance changing the "glide" mechanism as you see fit. Built with a totally transparent lower guard the saw additionally ensures youll have completely unimpaired visibility through each cut.
I. Compound Miter Saws On a compound miter saw the blade moves in three general directions. First the blade moves up and down in a chopping motion. Second the blade moves about 45-degrees to the left and right for miter cuts and lastly the blade will lean either to the left or to the left and right to perform bevel and double bevel cuts. Although compound miter saws are typically more portable and less expensive than sliding compound miter saws they also have less capacity for wider boards. Most often a compound miter saw will be unable to through-cut a wide board with a single pass. II. Sliding Compound Miter Saws A sliding compound miter saw does all of the things a compound miter saw does while also adding a few more things to the pot.
Miter saws can be used in a woodworking shop as a permanently installed tool or on the jobsite as a portable or semi-portable unit. I will discuss the construction of miter saw tables appropriate to both types of installations. The purpose of a miter saw table is two-fold: (1) to elevate the saw to a comfortable working height for the operator and (2) to provide a surface to the left and/or right of the saw for the extension of the fence and to provide support for long materials while being cut. If you have ever tried to cut a 45-degree miter at one end of a 2 x 6 x 12 you know why a miter saw table or roller stand is absolutely required. Very often miter saws are used to make repetitive cuts of the same length.
For starters a sliding compound miter saw is designed with two rail-like tubes that allow the blade to move back and forth in a larger range of motion. This grows crosscutting capacity by a few inches and allows users to through-cut wider boards (usually with one easy pass). Because of these tubes though sliding compound miters saws are typically heavier they are less portable and theyre more expensive. With the exception of some Bosch and Makita saws that utilize a kind of articulating arm in lieu of sliding-tubes sliding compound miters also require more room (especially at the rear of the saw) to work properly.