Miter Saw / November 23, 2018 / Tina Abrahamsson.
A fence can be attached to the back side of the 4 x 4. Use a 1 x 6 or 1 x 8 clear fir board for this purpose. As in the permanent table above the front of the fence must align perfectly with the miter saws metal fence. If a wider support surface is needed a second 4 x 4 can be mounted directly in front of the one with the fence attached to it. A Kreg Trak system with a flip-up stop can also be used on this portable miter saw table. Just make sure the wooden fence is ripped to the proper height to allow the flip-up stop to clear the table by 1/16". (Fence is 2 1/4" + above the top of the 4 x 4.) As for the support table I have used a plastic fold-up table from Costco. They come in various sizes to suit your particular need. Or you can make your own table out of 2 x 4s and 3/4" plywood. Design it so that the legs can fold up for transportation and storage.
For you to choose the right miter saw you have to know its features. Miter saws vary in brands designs and also its blades. The blade guard which is known as a safety blade. A laser guard which serves as a guide of the portion you are about to cut. The shaft lock which helps you in changing the blades of your miter saw. Then the dust bag basically collects the dust of your woodwork. The electric brake is the most important features of your miter saw. The electric brake is one of its safety features which automatically shut down the blade in case of emergency.
The saw must be mounted in this gap so that the top of the miter saw table is flush with the top of the saw table. The miter handle must be free to move its full travel in both directions left to right. Anticipate the need for this gap as you are framing the underside of your miter saw table because you will need to construct a shelf underneath to support the weight of the miter saw. You might want to make this shelf adjustable in micro increments so that you can get the top of the saw platform exactly flush to the top of the saw table. You can do this with lag screws with washers in sliding slots through the shelf sub-structure and into the table framing. Slightly loosen the lags and tap the table up or down with a rubber hammer before tightening the lags fully.
When searching for high-end power tools at a low price craftsmen should also look for reconditioned tools. Reconditioned tools or recons although sometimes hard to come by are an extremely great value bringing craftsmen the highest-performance tools at a tiny fraction of regular cost. Recons for some minor cosmetic or technical defect have been returned to the manufacturer for stringent inspection and restoration processes. These tools are tested and restored to meet rigid manufacturer standards and are then re-released with a "R" trailing the model number. This little "R" (and potentially hundreds of dollars) is truly the only difference between a brand new tool and a recon. The value with these tools is truly a no-brainer; when recons are available snatch them up as an incomparable investment. Dewalts DW718R and DW716R miter saws are tremendous examples of the value of buying reconditioned.